5 cm2 PEM single fuel cell hardware, serpentine flow pattern, attached heaters,* fittings, current collectors, gaskets, banana plugs.

25 cm2 PEM single fuel cell hardware, includes serpentine flow pattern, attached heaters,* fittings, current collectors, gaskets, banana plugs.

50 cm2 PEM single cell fuel cell hardware, serpentine flow pattern, attached heaters,* fittings, gold plated current collectors, aluminum end plates, gaskets, voltage monitor banana plugs

Suitable for PEM test
Suitable for large active area MEA test and stack below 125W
Reliable and precise humidity control, temperature control, flow rate control

The G20 is an economical system with expanded capability in low power fuel cell characterization. The G20 test station has been designed for small active area and single cell R&D testing.

Humidifier can be operated as a stand alone unit, with Fideris FCPower^TM control software, or as part of the Fideris Hydrogen Test Kit^TM. Wide dynamic range of gas flows from 0 to 10 slpm, Available with one or two gas humidification channels.

Each Gas Delivery Module offers Mass Flow Control of one gas or blending of two gases with turndown ratio of 1000 to 1 available in a single module! Mix and Match flow rates, gasses and liquids!

The output from multiple Liquid Delivery Modules may be combined to provide dynamically controlled liquid flow rates and compositions including Stoichiometric Control. Mix and Match flow rates, liquids and gases!

Single-ended and/or differential pressure transduces utilized to monitor pressure, Up to ten pressure monitoring ports in a single 1U, 2U, or 3U module!

Up to six individual temperature controlled switched receptacles available in one module to individually control and monitor the temperature of up to six heating devices

Experimentation kit consisting suitable for fuel cell cars and Tutorial product range, as well as Junior products.

Experimentation kit suitable for fuel cell cars and Tutorial product range, as well as Junior products.

The Membrane Conductivity Test Cell will allow the user to perform a four-probe conductivity test on a piece of plain membrane.

This product is compatable with Fuel Cell Technologies hardware 5cm2, 10cm2, 16cm2 and 25cm2.

This fuel cell test fixture is designed to be disassembled and reassembled in order to test PEM MEA's in a constant environment.