Categories

Sigracet 29 BC

Brand: SGL Carbon
Product Code: 1592002

Qty: - +
   - OR -   

This product has been discontinued and we are completely out of stock. Sigracet 29 BC was discontinued and permanently replaced by Sigracet 22 BB.

Sigracet 29 BC is a non-woven carbon paper with a Microporous Layer (MPL) that has been PTFE treated to 5 wt%.  It has a total thickness of 235 um (microns).  SGL 29 BC is a great low-cost alternative to conventional woven carbon paper Gas Diffusion Layer (GDL) materials.

The Sigracet Carbon Fiber Paper 29 Series is intended to combine the required production robustness and the excellent performance properties.  Stack developers and assemblers are benefiting from the following greatly improved characteristics:

  • Greatly improved homogeneity inter-lot and intra-lot.  The overall variability has been shown to be better than +/- 10% (2 sigma)
  • Greatly improved surface flatness
  • Greatly reduced occurrence of faulty spots on a roll
  • Best performance under various operating conditions
 
Sigracet 29 BC is the successor type to Sigracet 25 BC.  The thickness, areal weight and in-plane permeability (IPP) of 29 BC are designed to be comparable to 25 BC.  However the surface defect rate of Sigracet 29 BC is significantly reduced.
Gas Diffusion Layer Properties
Material Type Carbon Fiber Paper
Thickness 235 microns +/- 25 microns
Basic Weight (g/m²) 90 +/- 10 g/m²
Air Permeability (s) 1.00 +/- 0.60 cm³/(cm²*s)
Porosity (%) 80%
Compressibility ca. 19% (at 1 MPa)
Electrical Resistivity (through plane) < 12 mΩcm² (milliohms cm²)
IP Pressure Drop 0.8 bar (at 1 MPa)
Substrate PTFE Treatment 5%
Microporous Layer Yes, on one side

Write a review


Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: