Categories

Fuel Cell Voltage Monitoring Considerations

Fuel Cell Voltage Monitoring Considerations

Knowing what's happening inside a fuel cell is a critical function, especially as fuel cells are continuing to be developed. One important aspect of this is to measure the voltage of each cell in a stack. Although this may sound trivial, it can be more complex and more expensive than it may at first appear due to high voltages, high channel counts, communication types, etc. There are a few products commercially available that are designed specifically for fuel cell voltage monitoring.

You can find the Cell Voltage Monitors (CVMs) and other electronic measurement devices currently available on our webstore. One feature that set CVMs apart from other, more mainstream data acquisition systems is the fact that the signal side is completely isolated and electrically floating relative to the communication and power supply portion of the electronics. This allows high voltage stacks to be measured and the capability of cascading multiple CVMs together to measure the large numbers of cells in high voltage stacks. All of the units listed have this ability.

Another important feature in a CVM system is high-speed acquisition. This is especially important in systems with high cell counts since most CVM systems measure each channel in sequence and the larger the stack the longer it takes to measure all the cells. This allows the researcher to closely analyze any voltage anomalies during load transients, regardless of the number of cells being monitored.

The third important aspect in measuring fuel cell voltages is accuracy. Accuracy, in conjunction with speed, allows the control system (or the researcher) to better diagnose what is happening inside the fuel cell. Voltage characteristics of the cells can provide information about the humidification of each cell, the health of the catalyst, which cells may be exhibiting crossover, and a myriad of other information important to the operation of the fuel cell. There are a number of ways to ensure accurate voltage measurements. Accuracy begins with noise reduction and equipment selection. The CVM should be placed as close to the fuel cell being tested as possible, minimizing the cable length between the CVM and the fuel cell. This will reduce the amount of noise picked up by the cables and transmitted to the CVM. In addition, the CVM must be selected to provide as much accuracy as possible – It is far easier to filter and smooth a high accuracy signal than it is to try to obtain additional accuracy later.

These are the primary drivers of CVM selection, although many other factors may come into play: available communication standards, removable storage options, size, power consumption, etc. Overall, the total cost to implement the solution must be considered. Even if the unit cost may be slightly less for one unit, be aware of what other necessary components would cost, such as cabling, software, LabView drivers, etc. The FuelCellsEtc Cell Voltage Monitor includes all software and LabView drivers in the initial price while the cable is designed for a simple, low-cost IDC style connector and ribbon cable (similar to a hard-drive cable), resulting in an overall lowest cost solution even while providing superior performance characteristics than other solutions.

Posted by Fuel Cell Store

Products related to this article

Related Articles

Introduction to Fuel Cell Testing

Those who wish to learn more about fuel cells, and even to build their own, may also want to learn how to test those fuel cells. In this post, we will review some basic terms, and introduce low-cost testing equipment and more sophisticated testing setups. First, however, an understanding of the fuel cell and electrical basics will...

What Else Do I Need For My Fuel Cell
So, you have bought a fuel cell and are ready to start using it. Or are you? Did you plan on any of the ancillary components you might need? Depending on who you buy the fuel cell from and what model it is will determine what components come with the fuel cell and what you will need to buy. In general, a fuel cell system needs several things in order for it to work in any system: Hydrogen storage (which may also include Hydrogen production) Fuel Cell system Power conditioning Hydrogen Storage Even if you are generating your hydrogen on-site, you will ..

0 Comments To "Fuel Cell Voltage Monitoring Considerations"

Write a comment

Your Name:


Enter the code in the box below:

Your Comment:
Note: HTML is not translated!