- Fuel Cell Cars
- Fuel Cell Stacks
Fuel Cell Testing
- - Fixed Testing Systems
- - Liquid and Gas Delivery Systems
- - Fuel Cell Testing Hardware
- - Modular Testing Systems
- - Vacuum Tables and Temperature Controllers
- - Pressure Monitoring
- - Electronic Measurement and Control
- - Stack Humidification Systems
- - Ion Exchange Filters
- - Fuel Cell Testing Components
- Fuel Cell Components
- Hydrogen Equipment
- Power Devices
- Solar Power
- Hydro Power
- Wind Power
- Bioenergy Power
- Lab Accessories
- STEM Education
The HydroFILL PRO Adapter allows for a direct connection to the HydroFILL PRO Hydrogen outlet, enabling the HydroFILL PRO to be used as a source of ultra-pure hydrogen for almost any use without the use of the HydroSTIK. It is a straight adapter with no valves, pressure regulators, etc.
The HydroFILL produces Hydrogen at a rate of up to 3 L/hr and pressures of up to 3 MPa (435 psi). This adapter allows access to this hydrogen via a 1/8" plastic line (approximately 24" long) suitable for use with Swagelok or other fittings.
When used in conjunction with the HydroSTIK Fitting it could be used to provide remote filling of HydroSTIK metal hydride canisters. This would permit users to explore or manipulate the fill rate of the HydroSTIK by placing the HydroSTIK in a bath of ice-water to speed the fill rate, or warm water to slow it.
Please exercise caution and prudence when working with high pressure hydrogen. When working with hydrogen and metal hydrides, be sure the lines are thoroughly purged. The presence of any air, oxygen, moisture, or other contaminates in the lines in the presence of the metal hydride and hydrogen may result in a damage to the hydride and possibly a combustion event.
This adapter works with all models of the Hydrofill and Hydrostik.
Write a review
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: