- Fuel Cell Cars
- Fuel Cell Stacks
Fuel Cell Testing
- - Fixed Testing Systems
- - Liquid and Gas Delivery Systems
- - Fuel Cell Testing Hardware
- - Modular Testing Systems
- - Vacuum Tables and Temperature Controllers
- - Pressure Monitoring
- - Electronic Measurement and Control
- - Stack Humidification Systems
- - Ion Exchange Filters
- - Fuel Cell Testing Components
- Fuel Cell Components
- Hydrogen Equipment
- Power Devices
- Solar Power
- Hydro Power
- Wind Power
- Bioenergy Power
- Lab Accessories
- STEM Education
Thin gauge 12 x 12 inch Silicone Rubber Gasketing for use in fuel cell fixtures. Like other silicone, this rubber stays flexible over a wide temperature range, but its softness gives it better conformability than other rubber. A peel-off protective masking keeps this rubber free from dust and debris. Width and length tolerances are ±1/4". Durometer tolerance is ±5.
Teflon and fiberglass reinforced Teflon are used in high temperature applications such as High Temperature Polymer Electrolyte Membrane Fuel Cells (HT-PEMFC) and Phosphoric Acid Fuel Cells (PAFC).
HT6135 Silicon gasketing is a solid silicone elastomer. Silicone elastomers exhibit a natural shrinkage when the carrier or liner is removed. Thickness measurements do not include carrier or liner.
|Durometer||35A (soft) ±5|
|Tensile Strength (psi)||800|
|Temperature Range||-80°F to +425°F|
Write a review
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: