The Electrolyzer 65 is Double-Cell PEM electrolyzer stack, for production of hydrogen from distilled water.  The center of the cell houses the hydrogen side of the two individual cells.  The two outer sides of the cell have the function of supplying water and removing the oxygen produced.  The two individual cells are connected electrically in series.  Both cells have an electrode area of 16cm2.

The electrolyzer provided in this set is maintenance-free.  However, always remember to use fresh, distilled water each time and to drain the water from the storage tanks after use.

Specifications:

• Hydrogen Production Rate: 65 cm3/min
• Oxygen Production Rate: 32.5 cm3/min
• Hydrogen Storage Volume: 80 cm3/min
• Oxygen Storage Volume: 40 cm3/min
• Power Consumption: 16 Watts at 4.0 VDC
• Permissible Operating Voltage: 0 - 4 VDC
• Permissible Operating Current: 0 - 4.4 A
• Permissible Operating Pressure: 0 - 5 mbar
• Electrode Area: 2 cells at 16cm2 each
• Operating Medium: Distilled Water
• Dimensions (H x W x D): 9.9" x 9.9" x 4.7" (250 x 250 x 120 mm)
• Weight: 2.1 pounds (950 g)

About PEM Electrolyzers

The growing significance of PEM electrolyzers mirrors the development of fuel cells. Electrolyzers generate the hydrogen required by fuel cells from water in an environmentally conscious manner.  The electrical energy required for this purpose can be gained from renewable sources such as solar cells, wind farms or hydroelectric plants.

Water reacts in the electrolyzer under the influence of electrical energy according to the following formula: 2H2O = 2H2 + O2.  This process takes place in the MEA (membrane electrode assembly).  The MEA consists of the cathode, the anode, and a special polymer membrane (PEM) which is permeable to protons but which presents a barrier to electrons.  Your h-tec electrolyzer functions on the PEM principle. The energy stored in chemical form in the gases can be converted back to electrical energy in a fuel cell as and when required.

H-TEC Education E206 Electrolyzer 65 Manual

The electrolyser does not produce hydrogen when the solar cell is connected.
 
Cause 1:  The light intensity is insufficient.
 
Solution 1:  Check the power specifications of the light source. You need sufficient sunlight or halogen lamps with focused light such as the Sun Simulator Light. Energy-saving lamps, fluorescent tubes, etc. are not suitable for the operation of solar modules.
 
 
Cause 2:  You are using a double-cell electrolyser (electrolyser 10 or electrolyser cell 10) and are running it with a solar module for single cells.
 
Solution 2:  Use the appropriate solar module - the Tutorial Double Solar Module.
 
 
 
The electrolyser does not work despite being set up correctly.
 
You have not used distilled water. The cell is permanently damaged.

Write a review

Note: HTML is not translated!
    Bad           Good
Captcha

Electrolyzer 65

  • $330.00


Related Products

Measurement Set 1
Stack Experimentation Set Complete
Fuel Cell Monitor Pro 4.0
Single Electrolyzer Kit
Double Electrolyzer Kit
Single Electrolyzer
Electrolyzer 230
Storage 30

Storage 30

$21.00

Storage 80

Storage 80

$72.00

H-TEC Power Supply 22.5 W (4mm)
Solar Module Tutorial Double
Fuel Cell Stack 5
Fuel Cell Stack 10
4V/350mA Solar Panel
Measurement Set 2
Quattro Electrolyzer
Double Electrolyzer