- Fuel Cell Cars
- Fuel Cell Stacks
Fuel Cell Testing
- - Fixed Testing Systems
- - Liquid and Gas Delivery Systems
- - Fuel Cell Testing Hardware
- - Modular Testing Systems
- - Vacuum Tables and Temperature Controllers
- - Electronic Measurement and Control
- - Stack Humidification Systems
- - Ion Exchange Filters
- - Fuel Cell Testing Components
- - Portable Generators
- - Electrochemical Experiments
- Fuel Cell Components
- Hydrogen Equipment
- Hydrogen Drone
- Power Devices
- Solar Power
- Hydro Power
- Wind Power
- Bioenergy Power
- Lab Accessories
- STEM Education
The BT-115 Conductivity Cell holds the sample test membrane that can be built into your typical fuel cell hardware. It can be connected to the standard test stand to control and measure various parameters. The advantage of the BT-115 is the ability to distinguish voltage drop between ion creation and ion flow, leading to more accurate assessment of membrane conductivity and resistance. It may be used with most 5, 10, and 25cm² fuel cell test hardware. Connect the platinum wires to your potentiostat to apply voltage and measure current. The Conductivity Cell is designed for an in-plane, four-electrode measurement.
The advantage of the 4-electrode in-plane conductivity measurement is the ability to measure impedance (resistance) due only to charge transport and exclude interfacial and charge transfer resistances. By considering only resistance due to ion transport, accurate assessment of in-plane membrane conductivity can be made.
✔ Tests pure membrane samples. Fabrication of a catalyzed sample (CCM or MEA) is not required.
✔ In-plane, four electrode technique
✔ Control of humidity and pressure using your existing fuel cell test system
✔ High temperature testing (to 120°C)
✔ Membrane Conductivity Clamp is removable allowing you to use the clamp for tests in a beaker or a humidity chamber
• Temperature: Up to 120°C
• Gas Flow Rates: Determined by your test stand parameters
• Pressure: Determined by your test stand parameters
• Use with 5, 10, and 25 cm² fuel cell test hardware
This kit does not include fuel cell hardware.
General lead time of two to three weeks to be expected.
Write a review
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: