Categories

BT-115 Conductivity Cell Kit

Product Code: 72108116

Qty: - +
   - OR -   

The BT-115 Conductivity Cell holds the sample test membrane that can be built into your typical fuel cell hardware.  It can be connected to the standard test stand to control and measure various parameters.  The advantage of the BT-115 is the ability to distinguish voltage drop between ion creation and ion flow, leading to more accurate assessment of membrane conductivity and resistance.  It may be used with most 5, 10, and 25cm² fuel cell test hardware.  Connect the platinum wires to your potentiostat to apply voltage and measure current.  The Conductivity Cell is designed for an in-plane, four-electrode measurement.

The advantage of the 4-electrode in-plane conductivity measurement is the ability to measure impedance (resistance) due only to charge transport and exclude interfacial and charge transfer resistances. By considering only resistance due to ion transport, accurate assessment of in-plane membrane conductivity can be made.

BT Conductivity Clamp
Key Features Include:

✔ Tests pure membrane samples. Fabrication of a catalyzed sample (CCM or MEA) is not required.
✔ In-plane, four electrode technique
✔ Control of humidity and pressure using your existing fuel cell test system
✔ High temperature testing (to 120°C)
✔ Membrane Conductivity Clamp is removable allowing you to use the clamp for tests in a beaker or a humidity chamber

Operating Parameters:

• Temperature: Up to 120°C
• Gas Flow Rates: Determined by your test stand parameters
• Pressure: Determined by your test stand parameters
• Use with 5, 10, and 25 cm² fuel cell test hardware


This kit does not include fuel cell hardware.

General lead time of two to three weeks to be expected.

Write a review


Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: