- Fuel Cell Cars
- Fuel Cell Stacks
Fuel Cell Testing
- - Fixed Testing Systems
- - Liquid and Gas Delivery Systems
- - Fuel Cell Testing Hardware
- - Modular Testing Systems
- - Vacuum Tables and Temperature Controllers
- - Electronic Measurement and Control
- - Stack Humidification Systems
- - Ion Exchange Filters
- - Fuel Cell Testing Components
- - Portable Generators
- - Electrochemical Experiments
- Fuel Cell Components
- Hydrogen Equipment
- Power Devices
- Solar Power
- Hydro Power
- Wind Power
- Bioenergy Power
- Lab Accessories
- STEM Education
Fumapem FS-930-RFS membrane is perfluorinated cation exchange membrane - reinforced and stabilized with low resistance, high mechanical stability, low dimensional swelling, and high stability in acidic environment. The polymer composition of this membrane is based on the perflurosulfonic acid resin with short side chains.
Fumapem FS-930-RFS membrane comes in either a 10cm x 10cm or 19.5cm x 30cm size sheet.
Fumatech membranes are highly sensitive to differences in humidity and moisture content. Therefore the membranes can vary +/- 0.5cm from the original cut sizes. Also due to this sensitivity the manufacturer expects wrinkles to form, however soaking the membranes in deionized water will return the membranes to the full size planar state according to the manufacturer.
• Applications: Fuel Cell (H2 PEMFC)
• Cation Exchange Membrane
• Thickness (dry): 27 - 32 micrometers (1.06 - 1.26 mil)
• Sizes: 10cm x 10cm, 19.5cm x 30cm
The membrane is the transparent foil, delivered on a backing layer (colourless rigid PET foil). Peel off carefully the membrane from the backing layer or in the other way around, depending on the convenience. The membrane is ready for use.
Keep membrane package closed / sealed when unused. Unpack membrane only for direct use and process immediately after opening. Store, handle and process the membrane in a clean and dust-free area. Use only new and sharp knives or blades, when cutting the membrane. Always wear protective gloves when handling the membrane. Handle with care, be sure not to puncture, crease or scratch the membrane, otherwise leaks will occur. All surfaces in contact with the membrane during handling, inspection, storage and mounting must be smooth and free of sharp projections.
The membrane does not need any pretreatment and is ready for use. Please assemble the membrane in dry form. If you have any concerns about storage, chemical stability, and pretreatment please feel free to contact us for further information.
The membrane can be stored dry for an unlimited amount of time. However, the membrane has to be conditioned (washed and rinsed) prior to use.
Please note that a current lead time of one to two weeks is to be expected.
|Membrane||Cation Exchange Membrane|
|Thickness||27 - 32 µm (microns)|
|Appearance / Color||Transparent / Colourless|
|Tensile Strength - max. (MPa)||> 20 MPa|
|Elongation to Break (%)||> 150|
|Specific Area Resistance||< 0.02 Ω cm2|
|Specific Conductivity||> 120 mS cm-1|
|Counter Ion||H- form|
|Ion Exchange Capacity||1.15 meq g-1|
|Uptake in H2O at 25°C||17 wt %|
|Dimensional Swelling in H2O at 25°C||10 %|
Write a review
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: