- Fuel Cell Cars
- Fuel Cell Stacks
- Fuel Cell Testing
- Fuel Cell Components
- Hydrogen Equipment
- Power Devices
- Solar Power
- Hydro Power
- Wind Power
- Bioenergy Power
- Lab Accessories
- STEM Education
Fuel Cell Store’s Single Cell Interchangeable Test Hardware was designed by one of the leading companies in electrochemical research and development to be one of the highest quality and most flexible test fixtures on the market. The test fixture is custom in-house machined from stainless steel endplates to provide flat, even compression across the entire face of your test MEA. The plates are gold plated for maximum conductivity to alleviate parasitic contact losses during your testing. The cell comes with adhesive backed heater pads on each endplate to add heat to the cell fixture. To read the temperature of the cell, each endplate has a 1/8” smooth thermocouple port and an 10-32 tapped port for a surface mount temperature sensor.
Different onfigurations offered for this product in order to make use of this single cell fixture for various electrochemical applications such as graphite based intermediate plates, titanium intermediate plates, and nickel intermediate plates. Graphite plate option can be used for typical PEM fuel cell applications. Titanium plate option can be used for typical PEM electrolyzer applications. Nickel plate option can be used for solid membrane contaning alkaline fuel cells (no liquid electrolyte).
The test fixture comes with four 1/8” NPT x 1/4” compression fittings, all internal seal O-rings (the cell will also support flat gasket seals), Grade 5 nuts and bolts (with appropriate electrical insulators) for compression, 10-32 truss screws for electrical or thermal connections (one per endplate), 1/4”-20 brass bolt with copper washer for load connections(one per endplate), and a set of standard configuration of either 25cm2 or 5cm2, serpentine flow path plates.
25cm2 design or configuration comes with two gold plated endplates and two intermediate plates where the flow fields are machined directly on one face of the intermediate plates. There is a total of 4 plates in this design.
5cm2 design or configuration comes with two gold plated endplates and two intermediate plates where the flow fields are machined directly on one face of the intermediate plates, and two adapter plates where the reactants are channeled from endplates into the adapter plates and then into the intermediate plates and removed the same way. There is a total of 6 plates in this design.
Typical lead time is 8 - 12 weeks to ship.
Write a review
Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: