Lithium manganese nickel oxide (LMNO, LiMn1.5Ni0.5O4, SP-10) cathode powder

Product Code: 79080028

From $92.00

Available Options

* Grams:

Qty: - +
   - OR -   

Lithium manganese nickel oxide (LMNO, SP-10) cathode powder has the chemical formula of LiMn1.5Ni0.5O4 for the active material. LMNO is a cathode material that can be charged at high voltage (5V). Due to the high potential, this cathode active material has a higher energy density compared to lithium cobalt oxide and lithium iron phosphate. LMNO-based batteries can be used in high energy and high rate applications.

Material Characteristics:
Generic Name: Lithium manganese nickel oxide (LMNO, LiMn1.5Ni0.5O4, SP-10)
Formula: LiMn1.5Ni0.5O4
Average Particle Size: 4 - 7 microns
Specific Surface Area: 1.0 - 1.2 m2/gram
Electrical Characteristics:
Nominal Voltage vs. Li/Li+: 4.7 V
Minimum Capacity: 115 mAh/gram
Experimental Capacity: ≥ 125 mAh/gram (3.5 - 5.0 V @ 0.1C)
Recommended Operating Conditions:
Maximum Charge Voltage: 5.0 V vs. Li/Li+
Maximum Charge Current: 3C
Cutoff Voltage for Discharge: 3.5 V vs. Li/Li+
Maximum Discharge Current: 3C
Precautions For Safe Storage and Handling:

Personal protective equipment should be used at all times. Avoid contact with eyes and skin. Ensure adequate ventilation and avoid inhalation of dusts. Wash hands thoroughly after handling. Store in a dry and well-ventilated place. Avoid moisture. Refer to SDS for complete safety information of this material.

NOTE: Fuel Cell Store believes that the information in this spec sheet is an accurate description of the typical use of the product. However, Fuel Cell Store disclaims any liability for incidental or consequential damages, which may result from the use of their products that are beyond its control. Researchers should use this information only as a supplement to other information gathered by them and should make independent judgment of suitability of this information to ensure proper use and protect the health and safety of employees. Therefore, it is the end user's responsibility to thoroughly test the product in their particular application to determine its performance, efficacy, and safety. Nothing contained herein is to be considered as permission or a recommendation to infringe any patent or any other intellectual right.

A typical lead time of 1-2 weeks to be expected for this product.

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: