Lithium titanate (LTO, Li4Ti5O12, BE-10) anode powder

Product Code: 79080043

From $92.00

Available Options

* Grams:

Qty: - +
   - OR -   

Lithium titanate (which is also known as lithium titanium oxide or LTO) has the chemical formula of Li4Ti5O12 and it is mainly used as the anode active material in the Li-ion batteries that demand high rate, long cycle life, and high efficiency. LTO spinel anode powder has exceptional electrochemical stability. LTO-based lithium-ion batteries are considered safer and have a wider operating temperature range compared to other batteries.

Material Characteristics:
Generic Name: Lithium titanate, lithium titanium oxide, or LTO
Formula: Li4Ti5O12
Average Particle Size: 1.5 -  3 microns
Specific Surface Area: 5 - 9 m2/gram


Electrical Characteristics:
Nominal Voltage vs. Li/Li+: 1.53 V
Minimum Capacity: 150 mAh/gram
Experimental Capacity: 165 mAh/gram (1.2 - 2.3 V @ 0.1C)


Recommended Operating Conditions:
Maximum Charge Voltage: 3.0 V vs. Li/Li+
Maximum Charge Current: 5C
Cutoff Voltage for Discharge: 1.0 V vs. Li/Li+
Maximum Discharge Current: 10C


Precautions For Safe Storage and Handling:

Personal protective equipment should be used at all times. Avoid contact with eyes and skin. Ensure adequate ventilation and avoid inhalation of dusts. Wash hands thoroughly after handling. Store in a dry and well-ventilated place. Avoid moisture. Refer to SDS for complete safety information of this material.

NOTE: Fuel Cell Store believes that the information in this spec sheet is an accurate description of the typical use of the product. However, Fuel Cell Store disclaims any liability for incidental or consequential damages, which may result from the use of their products that are beyond its control. Researchers should use this information only as a supplement to other information gathered by them and should make independent judgment of suitability of this information to ensure proper use and protect the health and safety of employees. Therefore, it is the end user's responsibility to thoroughly test the product in their particular application to determine its performance, efficacy, and safety. Nothing contained herein is to be considered as permission or a recommendation to infringe any patent or any other intellectual right.

A typical lead time of 1-2 weeks to be expected for this product.

Write a review

Your Name:

Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:

Related Products (15)